Kia Optima Manuals

Kia Sportage: Camshaft Position Sensor (CMPS): Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Sportage: Camshaft Position Sensor (CMPS): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS): Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
   
•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.

[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the heater protect cover (Refer to "Intake And Exhaust System" in EM group).
3.
Disconnect the camshaft position sensor connector (A).
4.
Remove the hanger and the protector.
5.
Remove the installation bolt, and then remove the sensor.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage.
   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Camshaft Position Sensor (CMPS): Schematic Diagrams
Circuit Diagram...
Knock Sensor (KS): Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin...
See also:

Seat Belt Pretensioner (BPT): Description and Operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps ...

Specifications
Specifications Purge Control Solenoid Valve (PCSV) ? Specification ItemSpecificationCoil Resistance (?)19.0 ~ 22.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ? Type: Piezo-Resistive ...

Front Driveshaft: Components and Components Location
Components 1. Front driveshaft (LH)2. inner shaft3. Front driveshaft (RH) 1. Split pin2. Castle nut3. washer4. BJ assembly5. Clip A6. BJ boot band7. BJ boot8. Dynamic damper band9. Dynamic d ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.062