Kia Sportage: Canister Close Valve (CCV): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV): Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the CCV connector.

3.	Measure resistance between the CCV terminal 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.	Disconnect the vapor hose connected with the canister from the CCV.

6.	Connect a vacuum pump to the nipple.

7.	Ground the CCV control line and apply battery voltage to the CCV power supply line.

8.

Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Lift the vehicle.

3.	Disconnect the canister close valve connector (A).

4.	Disconnect the ventilation hose (B,C) from the fuel tank air filter and canister close valve.

5.	Remove the fuel tank air filter and canister close valve assembly (A) after removing the mounting nut (B).

6.	Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Installation is reverse of removal.

Canister Close Valve (CCV): Schematic Diagrams

Circuit Diagram...

Fuel Delivery System

...

See also:

Camshaft Position Sensor (CMPS): Description and Operation
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Muffler: Components and Components Location
Components 1. Front muffler2. Catalytic converter3. Center muffler4. Main muffler5. Gasket ...

Front windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0522