Kia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS): Repair procedures

Inspection

Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A).

3.	Remove the protector (A).

4.	Remove the installation bolt (A), and then remove the crankshaft position sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Installation is reverse of removal.

Crankshaft position sensor installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Crankshaft position sensor protector installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Crankshaft position sensor protector installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Crankshaft Position Sensor (CKPS): Schematic Diagrams

Circuit Diagram...

Camshaft Position Sensor (CMPS): Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto...

Kia Sportage: Crankshaft Position Sensor (CKPS): Repair procedures

See also:

Categories