Kia Sportage: Cruise Control Switch: Repair procedures

Removal and Installation

Disconnect the battery (-) terminal.

Tightening torque:

Without battery sensor :

7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)

With battery sensor :

4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)

2.	Remove the air-bag module from the steering wheel. ( Refer to RT group)

3.	Remove the steering wheel. (Refer to ST group)

4.	Remove the cruise control switch (A) after unfastening the 2 screws and disconnecting the switch connector.

5.	Installation is reverse order of removal.

Inspection

Measuring Resistance

1.	Disconnect the cruise control switch connector from the control switch.

Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).

3.	If not within specification, replace switch.

Measuring Voltage

1.	Connect the cruise control switch connector to the control switch.

Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).

3.	If not within specification, inspect the control switch resistance. The measuring resistance value is not within specification, replace the switch and measure the voltage again.

4.	If resistance is OK but, measuring voltage is not within specification, inspect the wiring harness and connectors between the switch and the ECM.

Circuit Diagram...

...

Categories