Kia Sportage: CVVT Oil Control Valve (OCV): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV): Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the OCV connector.

3.	Measure resistance between the OCV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

[Bank 1 / Intake]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the OTS (A).

3.	Disconnect the CVVT oil control valve connector (B).

4.	Remove the installation bolt (C), and then remove the valve from the engine.

[Bank 1 / Exhaust]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the CVVT oil control valve connector (A).

3.	Remove the installation bolt (B), and then remove the valve from the engine.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply engine oil to the valve O-ring.

Installation is reverse of removal.

CVVT oil control valve installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CVVT Oil Control Valve (OCV): Schematic Diagrams

Circuit Diagram...

Fuel Pressure Control Valve: Description and Operation

Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on var...

Kia Sportage: CVVT Oil Control Valve (OCV): Repair procedures

See also:

Categories