Kia Sportage: Description and Operation
Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Electrical System / Ignition System / Description and Operation
| Description |
Ignition timing is controlled by the electronic control
ignition timing system. The standard reference ignition timing data for
the engine operating conditions are preprogrammed in the memory of the
ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up
condition, etc.) are detected by the various sensors. Based on these
sensor signals and the ignition timing data, signals to interrupt the
primary current are sent to the ECM. The ignition coil is activated, and
timing is controlled.
...
Ignition System
On-vehicle Inspection
Spark Test
1.
Disconnect the ignition coil connectors (A).
2.
Remove the ignition coils (A).
3.
Using a spark plug socket, remove the spark plug.
4.
Install th...
Repair procedures
See also:
Rear Glass Defogger Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to BE - "Audio")
3.
Remove the heater and A/C controller (A) after disconnecting the con ...
Selective Catalytic Reduction
The Selective Catalytic Reduction (SCR) system uses urea solution as a reducing agent to convert nitrogen oxides into
nitrogen and water.
Warning
Using a vehicle that does not consume t ...
Curtain Airbag (CAB) Module: Description and Operation
Description
Curtain airbags are installed inside the headliner (LH and
RH) and protect the driver and passenger from danger when side crash
occurs. The SRSCM determines deployment of curtain ai ...
Categories
- Home
- Kia Sportage NQ5 (2022-2026) Owner's Manual
- Kia Sportage QL (2015-2019) Owner's Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owner's Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © sl.kispmanual.com 2014-2026 - 0.0727