Kia Sportage: Front Impact Sensor (FIS): Repair procedures - SRSCM - RestraintKia Sportage: Front Impact Sensor (FIS): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Restraint / SRSCM / Front Impact Sensor (FIS): Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A) and air cleaner assembly (B). (Driver front impact sensor only)

3.
Disconnect the front impact sensor connector (A).

4.
Remove the front impact sensor mounting bolt (B).
5.
Remove the front impact sensor.
Installation
   
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.

Tightening torque :
7.0 ~ 9.0 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.6 lb.ft)

3.
Connect the front impact sensor connector.
4.
Install the air duct and air cleaner assembly. (Driver front impact sensor only)
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS): Components and Components Location
Components...
Side Impact Sensor (SIS): Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar n...
See also:

Power outlet
Front Rear The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps ...

Gauges
The Kia Sportage gauges show key driving information, including vehicle speed, engine speed, fuel level and engine coolant temperature. Speedometer Figure 1. Type A ...

Fluid: Repair procedures
Service Adjustment Procedure Oil level Check     When checking the oil level, be careful not to enter dust, foreign matters, etc. from fill hole. 1. Remove the ey ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.06