Kia Optima Manuals

Kia Sportage: Front Wheel Transfer Assembly: Repair procedures - Transfer Assembly - 4 Wheel Drive (4WD) SystemKia Sportage: Front Wheel Transfer Assembly: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / 4 Wheel Drive (4WD) System / Transfer Assembly / Front Wheel Transfer Assembly: Repair procedures

Removal
   
It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is required to determine the sizes of the transfer assembly spacers when disassembling and reassembling the transfer assembly. If putting wrong sized spacers in the transfer assembly, it may cause noise and vibration.So, if inner parts of the transfer assembly need to be replaced, the transfer assembly should be replaced with new one.
1.
Lift up the vehicle.
2.
Remove the propeller shaft bolts.(A-4ea)
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)

3.
Remove the right driveshaft (passenger side) from the transfer case. (Refer to "Drive shaft" in DS group)
4.
Remove the roll rod bracket(C) after removing bolt(A,B).
Tightening torque :
(B) 49.0~63.7N.m (5.0~6.5kgf.m, 36.2~47.0lb-ft)
(D) 107.9~127.5N.m (11~13kgf.m, 79.6~94.1lb-ft)

5.
Remove the sub frame. ("Front suspension system" in SS group)
6.
Remove the transfer case up and down mounting bolt (A-4ea, B-1ea).
Tightening torque :
(A, B) 60.8~65.7N.m (6.2~6.7kgf.m, 44.8~48.5lb-ft)

7.
Remove the transfer case (C) with the lever after supporting the transfer case with a jack.
Installation
1.
Installation is the reverse of removal.
   
1)
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2)
Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA OR EQUIVALENT

3)
Install the propeller shaft near runout marking (Transfer assembly 1ea(A), propeller shaft 1ea(B)).

Front Wheel Transfer Assembly: Components and Components Location
Components Location 1. Automatic transaxle2. Transfer assembly3. Propeller shaft4. Coupling assembly5. Differential assembly...
Oil Seal: Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) (Refer to "Front Driveshaft" in Driveshaft and axle) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). ...
See also:

Cargo security screen
Use the cargo security screen to hide items stored in the cargo area. To use the cargo security screen, pull the handle backward and insert the edges into the slots. When not in use, place t ...

Hands Free Mic: Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Remove the handsfree mic (A) after loosening the connector and ...

Opening the tailgate
The tailgate is locked or unlocked when all doors are locked or unlocked with the key, transmitter (or smart key) or central door lock switch. If unlocked, the tailgate can be opened by pres ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0569