Kia Optima Manuals

Kia Sportage: Passenger Airbag (PAB) Module: Repair procedures - Airbag Module - RestraintKia Sportage: Passenger Airbag (PAB) Module: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Restraint / Airbag Module / Passenger Airbag (PAB) Module: Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the crash pad garnish. (Refer to the Body group- crash pad).
3.
Disconnect the passenger airbag connector and remove the PAB mounting bolt.

4.
Remove the crash pad. (Refer to the Body group- crash pad).
   
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the heater duct from the crash pad.
6.
Remove the mounting nuts(4EA) from the crash pad. Then remove the passenger airbag.
   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque :
5.9 ~ 6.9 N.m (0.6 ~ 0.7 kgf.m, 4.3 ~ 5.1 lb-ft)

4.
Install the heater duct to the crash pad.
5.
Install the crash pad. (Refer to the Body group- crash pad)
6.
Tighten the passenger airbag mounting bolt.
Tightening torque :
18.6 ~ 26.5 N.m (1.9 ~ 2.7 kgf.m, 13.7 ~ 19.2 lb-ft)
7.
Connect the passenger airbag harness connector to the SRS main harness connector.
8.
Reinstall the crash pad garnish. (Refer to the Body group- crash pad)
9.
Reconnect the battery negative cable.
10.
After installing the passenger airbag (PAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Passenger Airbag (PAB) Module: Components and Components Location
Components...
Side Airbag (SAB) Module: Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag b...
See also:

Glove box cooling
You can keep beverage cans or other items cool using the open/close lever of the vent installed in the glove box. 1.Turn on the air conditioning (A/C) system. 2.Move the open/close lever (1) of ...

Rear Upper Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Weight of the trailer tongue
The tongue load of any trailer is an important weight to measure because it affects the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb weight of the vehicle, any ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.054