Kia Optima Manuals

Kia Sportage: Purge Control Solenoid Valve (PCSV): Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Sportage: Purge Control Solenoid Valve (PCSV): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV): Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.
Remove the valve from the bracket in the direction of the arrow.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Use care to keep foreign material out of the valve.
   
•
Install the purge control solenoid valve after lifting the support pin (A) of the bracket.

1.
Installation is reverse of removal.
Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Purge Control Solenoid Valve (PCSV): Schematic Diagrams
Circuit Diagram...
CVVT Oil Control Valve (OCV): Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...
See also:

Closing the tailgate
To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. Make sure your hands, feet and other parts of your body are safely out of the wa ...

Care of seat belts
Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse. ...

Heating and air conditioning
1.Start the engine. 2.Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3.Set the temperature control to the desired position. ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0737