Kia Optima Manuals

Kia Sportage: Rear Seat Belt: Repair procedures - Seat Belt - Body (Interior and Exterior)Kia Sportage: Rear Seat Belt: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Body (Interior and Exterior) / Seat Belt / Rear Seat Belt: Repair procedures

Replacement
Rear Seat Belt Replacement
   
•
When installing the belt, make sure not to damaged the retractor.
1.
Remove the following items first.
•
Rear seat assembly
(Refer to the BD group - "Rear Seat")
•
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - "Interior Trim")
2.
Remove the clips and rear transverse trim (A).

3.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
After loosening the mounting bolts, then remove the rear seat mounting bracket (A).

5.
Using a screwdriver or remover, remove the lamp (A).
6.
Disconnect the connector (B).
7.
After loosening the mounting screws, then remove the luggage side trim (C).

8.
Disconnect the connector (A).

9.
After loosening the mounting bolt and screws, then remove the rear pillar trim (A).

10.
After loosening the mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

11.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connectors are plugged in properly.
Rear Seat Belt Buckle Replacement
1.
Remove the rear seat.
(Refer to the BD group - "Rear Seat")
2.
After loosening the mounting bolt, then remove the rear seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
[LH]

[RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Installation is the reverse of removal.
Front Seat Belt: Repair procedures
Replacement Front Seat Belt Replacement     • When installing the belt, make sure not to damaged the pretensioner. 1. Remove the following items first : ...
Body Electrical System
...
See also:

Remote keyless entry system operations
Lock (1) All doors (and tailgate) are locked if the lock button is pressed. If all doors (and tailgate) are closed, the hazard warning lights will blink once to indicate that all doors (and tail ...

RCV Control Solenoid Valve: Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV control solenoid valve connector. 3. Measure resistance between the valve terminals 1 and 2. 4. Check that the resista ...

Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to con ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0518