Kia Optima Manuals

Kia Sportage: Repair procedures - Evaporative Emission Control System - Emission Control SystemKia Sportage: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Emission Control System / Evaporative Emission Control System / Repair procedures

Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
Engine
Operating
Condition
Applied
Vacuum
Result
Idle
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum is held
3,000rpm

2.
Check the following points with applied vacuum at the purge control solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
Engine
Operating
Condition
Applied
Vacuum
Result
Idle
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum is held
Within 3 minutes after engine start at 3,000 rpm
 Try to apply vacuum
 Vacuum is released
In 3 minutes after engine start at 3,000 rpm
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum will be held momentarily, after which, it will be released

[PCSV Inspection]
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the PCSV connector (A).
3.
Disconnect the vapor hose (B) which is connected to the intake manifold from the PCSV.

4.
After connecting a vacuum pump to the nipple, apply vacuum.
5.
With the PCSV control line grounded, check the valve operation with battery voltage applied to the PCSV(Open) and removed(Closed).
Battery Voltage
Valve
Vacuum
Connected
Open
Released
Disconnected
Close
Maintained

6.
Measure the coil resistance of the PCSV.
Specifications:
19.0 ~ 22.0? [20°C(68°F)]
[EVAP. Leakage Test]
1.
Select "Evap. Leakage Test".

2.
Proceed with the test according to the screen introductions.

Schematic Diagrams
Schematic Diagram Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by t...
Canister: Repair procedures
Removal 1. Remove the fuel tank. (Refer to "Fuel tank" in FL group.) 2. Disconnect the vapor tube quick-connector (B) and the ventilation hose (A). 3. Remove the canister in the direction ...
See also:

Starting the engine
WARNING Wear suitable footwear when driving the Kia Sportage. Shoes such as high heels or ski boots may make it harder to operate the brake and accelerator pedals correctly. ...

Camshaft: Repair procedures
Removal Timing chain cover removal is not required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damagin ...

ACC(Accessory)
Orange indicator • With automatic transaxle Press the ENGINE START/STOP button while it is in the OFF position without depressing the brake pedal. If the ENGINE START/STOP button is in the AC ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0659