Kia Sportage: Temperature Control Actuator: Repair procedures - Heater - Heating,Ventilation, Air ConditioningKia Sportage: Temperature Control Actuator: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Heating,Ventilation, Air Conditioning / Heater / Temperature Control Actuator: Repair procedures

Inspection
1.
Ignition "OFF"
2.
Disconnect the connector of temperature control actuator.
3.
Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool position when connecting in the reverse.
[Drive]

1. -
2. -
3. Hot position
4. Cool position
5. Sensor ground
6. Feedback signal
7. 5V (Vcc)

4.
Check the voltage between terminals 5 and 6(Drive).
Specification
Door position
Voltage(5-6)
Error detecting
Max. cooling
0.4 ± 0.15V
Low voltage : 0.1V or less
Max. heating
4.6 ± 0.15V
High voltage : 4.9V or more

[Passenger]

1. -
2. -
3. Cool position
4. Hot position
5. 5V (Vcc)
6. Feedback signal
7. Sensor ground

5.
Check the voltage between terminals 6 and 7(Passenger).
Specification
Door position
Voltage(6-7)
Error detecting
Max. cooling
0.4 ± 0.15V
Low voltage : 0.1V or less
Max. heating
4.6 ± 0.15V
High voltage : 4.9V or more

It will feedback current position of actuator to controls.
6.
If the measured voltage is not specification, substitute with a known-good temperature control actuator and check for proper operation.
7.
If the problem is corrected, replace the temperature control actuator.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the left extension cover (A).

3.
Remove the left shower duct (A).

4.
Disconnect the temperature control actuator connector (A).
5.
Loosen the mounting screw and then remove the temperature control actuator (B).

6.
Remove the right extension cover (A).

7.
Remove the main crash pad.
(Refer to BD group - "Crash Pad")
8.
Remove the right shower duct (A).

9.
Disconnect the temperature control actuator connector (A).
10.
Loosen the mounting screw and then remove the temperature control actuator (B).

11.
Installation is the reverse order of removal.
Temperature Control Actuator: Description and Operation
Description 1. Heater unit includes mode control actuator and temperature control actuator. 2. Temperature control actuator is located at the heater unit. It regulates the temperature by the...
Mode Control Actuator: Components and Components Location
Component Location...
See also:

Cruise Control (CC). Cruise Control operation
Cruise indicator Set speed Cruise Control allows the Kia S ...

Accelerator Pedal: Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B), th ...

Engine compartment fuse panel
✽ NOTICE The actual fuse/relay panel label may differ depending on equipment/ options. ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0622