Kia Sportage: Thermostat: Repair procedures - Cooling System - Engine Mechanical SystemKia Sportage: Thermostat: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Mechanical System / Cooling System / Thermostat: Repair procedures

Removal and Installation
   
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overheat.
1.
Drain engine coolant so its level is below thermostat.
2.
Disconnect the radiator lower hose (A).

3.
Remove water inlet fitting (C), gasket (B) and thermostat (A).

Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)

4.
Installation is reverse order of removal.
   
•
Install the thermostat with the jiggle valve upward.
•
When assembling the thermostat, place the thermostat on the housing with a protrusion of thermostat matching with a groove of the housing and install the gasket and inlet fitting. Be careful the thermostat doesn’t get out of the groove on the housing.
5.
Fill the engine coolant.
6.
Start the engine and check for leaks.
7.
Recheck the coolant level.
Inspection
1.
Immerse thermostat in water heated to over 95°C (203°F), then heat for at least 3 minutes to check valve lift.

   
•
Do not use water below 95°C (203°F).
•
Do not directly heat unit as this will damage thermostat.
2.
Check the valve opening temperature.

Valve opening temperature: 82 ± 1.5°C (179.6 ± 2.7°F)
Full opening temperature: 95°C (203°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8mm (0.3in.) or more at 95°C (203°F)

If the valve lift is not as specified, replace the thermostat.
Water pump: Troubleshooting
Troubleshooting Water Pump SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming u...
Thermostat: Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Reti...
See also:

Dimensions
*1 with roof rack *2 with 215/70R16 tire *3 with 225/60R17 tire *4 with 235/55R18 tire ...

To defog inside windshield
1.Set the fan speed to the desired position. 2.Select desired temperature. 3.Press the defroster button (). 4.The outside (fresh) air position will be selected automatically and the air conditi ...

Aluminum wheel maintenance
The aluminum wheels are coated with a clear protective finish. Do not use any abrasive cleaner, polishing compound, solvent, or wire brushes on aluminum wheels. They may scratch or damage the f ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0557