Kia Sportage: Transaxle Oil Temperature Sensor: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor: Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Remove the air duct (A).

Remove the air cleaner assembly.

(1)	Disconnect the breather hose (A) and brake booster intensifier hose.

(2)

Disconnect the air intake hose and then remove the air cleaner assembly (B).

Tightening torque

Hose clamp bolt:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Air cleaner assembly bolts:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

4.	Disconnect the solenoid valve connector (A).

5.	Measure resistance between sensor signal terminal and ground terminal.

6.	Check that the resistance is within the specification.

Removal

1.	Change the shift lever to "N" range.

2.	Remove the valve body assembly. (Refer to "Valve Body" in Hydraulic System)

3.	Disconnect the input & output speed sensor connector (A).

Loosen the main connctor bolt (B).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.	Dissconnect the solenoid valve connector (A).

6.	Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it.

Installation

Install in the reverse order of removal.

•	Adding Automatic Transaxle Fluid(ATF). (Refer to "Fluid" in Hydraulic System in this group)

•	Use new valve body gasket (A).

Transaxle Oil Temperature Sensor: Schematic Diagrams

Circuit Diagram...

Input Speed Sensor: Description and Operation

Description Input Speed Sensor is a vital unit that measures the rate of rotation of the input shaft inside the transmission and delivers the readings to the TCM. The sensor prov...

Kia Sportage: Transaxle Oil Temperature Sensor: Repair procedures

See also:

Categories