Kia Optima Manuals

Kia Sportage: Windshield Wiper-Washer Switch: Repair procedures - Windshield Wiper/Washer - Body Electrical SystemKia Sportage: Windshield Wiper-Washer Switch: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.

   
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the light switch connector (A) and the wiper switch connector (B).

4.
Remove the wiper switch (A) by pushing the lock pin (B).
   
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.
Remove the steering wheel.
(Refer to ST group - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to RT group - "Airbag module")
7.
Remove the multifunction switch assembly (A) after loosening screws (2EA).

Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Components and Components Location
Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor (Front)6. Washer reservoir7. Wash...
Front Wiper Motor: Components and Components Location
Component Location 1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector...
See also:

Front windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Accelerator Position Sensor (APS): Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors ...

Use approved window washer anti-freeze in system
To keep the water in the window washer system from freezing, add an approved window washer anti-freeze solution in accordance with instructions on the container. Window washer anti-freeze is avail ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0526