Kia Sportage: Alternator: Repair procedures| Removal and Installation |
| 1. |
Disconnect the battery negative terminal first, then the positive terminal.
|
| 2. |
Disconnect the A/C compressor switch connector (A) the alternator connector (B), and the cable from alternator "B" terminal (C).
|
| 3. |
Remove the drive belt (A) after turning the drive belt tensioner (B) counterclockwise.
|
| 4. |
Pull out the through bolt and then remove the alternator (A).
|
| 5. |
Installation is the reverse order of removal. |
| Disassembly |
| 1. |
Remove the alternator cover (A) using a screw driver after loosening the nuts (B).
|
| 2. |
Remove the slip ring guide (A) and then loosen the mounting bolts and disconnect the brush holder assembly (B).
|
| 3. |
Remove the pulley (A) using the SST (09373-27000) (B).
|
| 4. |
Loosen the 4 through bolts (A).
|
| 5. |
Disconnect the rotor (A) and cover (B).
|
| 6. |
Reassembly is the reverse order of disassembly. |
| Inspection |
| Inspect Rotor |
| 1. |
Check that there is continuity between the slip rings (C).
|
| 2. |
Check that there is no continuity between the slip rings and the rotor (B) or rotor shaft (A). |
| 3. |
If the rotor fails either continuity check, replace the alternator. |
| 1. |
Check that there is continuity between each pair of leads (A).
|
| 2. |
Check that there is no continuity between each lead and the coil core. |
| 3. |
If the coil fails either continuity check, replace the alternator. |
RCV Control Solenoid Valve: Schematic Diagrams
Circuit Diagram
...
Temperature Control Actuator: Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect the connector of temperature control actuator.
3.
Verify that the temperature control actuator operates to the
hot position when connecting 12V ...
Junction Crossing function: (if equipped)
When Junction Crossing detects a potential collision while the Kia Sportage is crossing an intersection, it responds
in stages. Depending on the situation, the system may issue a warning, assist wi ...