Kia Optima Manuals

Kia Sportage: Input Speed Sensor: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemKia Sportage: Input Speed Sensor: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor: Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System of this group)
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding Automatic Transaxle Fluid (ATF).
(Refer to "Fluid" in Hydraulic System of this group)
•
Use new valve body gasket (A).

Input Speed Sensor: Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed...
Output Speed Sensor: Description and Operation
Description The Output Speed Sensor is a vital unit that measures the rate of rotation of the transmission''s turbine shaft and output shaft, and delivers the readings to the TCM. ...
See also:

High beam indicator
This indicator illuminates when the headlights are on and in the high beam position or when the turn signal lever is pulled into the Flash-to- Pass position. ...

Rail Pressure Sensor (RPS): Troubleshooting
Signal Waveform ...

Intake Manifold: Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening torque 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) 3. Remove the ai ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.072