Kia Sportage: Interior: Body Repair| Interior A |

|
|
|
| Front pillar trim mounting hole (O8.5) | Front pillar trim mounting hole (O7) | Cowl crossbar mounting hole (O9) |
|
|
|
| Front door checker mounting hole (O13) | Cowl side trim mounting hole (O8.5) | Seatbelt height adjust upper mounting hole (O14.5) |
|
| |
| Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
| Interior B |

|
|
|
| Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
|
|
|
| Rear door checker mounting hole (O13) | Rear seatbelt anchor mounting hole (O19) | Rear seat striker mounting hole (O9) |
|
|
|
| Wheel house panel tooling hole (O12) | Rear door striker mounting hole (O13) | Rear pillar trim mounting hole (O8.5) |
|
| |
| Rear pillar trim mounting hole (O8.5) | Transverse rear trim mounting hole (O8.5) |
| Interior C |

|
|
|
| Front pillar trim mounting hole (O8.5) | Front pillar trim mounting hole (O7) | Cowl crossbar mounting hole (O9) |
|
|
|
| Cowl side trim mounting hole (O8.5) | Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) |
|
| |
| Front seatbelt retractor mounting hole (O12.2) | Front seat mounting hole (O11) |
| Interior D |

|
|
|
| Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
|
|
|
| Rear seatbelt anchor mounting hole (O19) | Rear seat striker mounting hole (O9) | Wheel house panel tooling hole (O12) |
|
|
|
| Rear pillar trim mounting hole (O8.5) | Rear pillar trim mounting hole (O8.5) | Transverse rear trim mounting hole (O8.5) |
| ||
| Rear floor panel tooling hole (O6) |
Driving on grades
Reduce speed and shift to a lower gear before you start down a long or steep
downgrade. If you don’t shift down, you might have to use your brakes so much that
they would get hot and no longer o ...
SRS Control Module (SRSCM): Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Disconnect the DAB, PAB, SAB, CA ...
Temperature Control Actuator: Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect the connector of temperature control actuator.
3.
Verify that the temperature control actuator operates to the
hot position when connecting 12V ...