Kia Sportage: Manifold Absolute Pressure Sensor (MAPS): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS): Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the MAPS at idle and IG ON.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the manifold absolute pressure sensor connector (A).

3.	Remove the installation bolts (B), and then remove the sensor from the surge tank. [MAPS #1] [MAPS #2]

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Insert the sensor in the installation hole and be careful not to damage.

Installation is reverse of removal.

Manifold absolute pressure sensor installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Manifold Absolute Pressure Sensor (MAPS): Schematic Diagrams

Circuit Diagram...

Intake Air Temperature Sensor (IATS): Description and Operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t...

Kia Sportage: Manifold Absolute Pressure Sensor (MAPS): Repair procedures

See also:

Categories