Kia Sportage: Oil Cooler: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Mechanical System / Lubrication System / Oil Cooler: Repair procedures

Removal

1.	Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining.

2.	Disconnect the oil cooler coolant hoses (A).

3.	Remove the oil filter (A).

4.	Loosen the mounting bolt (A) and remove the oil cooler assembly (B).

Installation

Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).

Tightening torque:

44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Fix position of oil cooler stopper(A) where oil cooler resists on ladder frame stopper (B).

Apply a light coat of engine oil to the oil filter packing surface (A), and then install the oil filter.

Tightening torque:

11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

3.	Connect the oil cooler coolant hoses (B).

4.	Fill the radiator with coolant and check for leaks.

Balance Shaft & Oil Pump: Repair procedures

Removal BSM (Balance Shaft Module) Chain System 1. Remove the timing chain. (Refer to Timing System in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tens...

Oil Pressure Switch: Repair procedures

Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal...

Kia Sportage: Oil Cooler: Repair procedures

See also:

Categories