Kia Optima Manuals

Kia Sportage: Steering Angle Sensor: Description and Operation - ESC(Electronic Stability Control) System - Brake SystemKia Sportage: Steering Angle Sensor: Description and Operation

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Brake System / ESC(Electronic Stability Control) System / Steering Angle Sensor: Description and Operation

Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESC-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe relay, etc.) of the EPS system are located inside the steering column & EPS unit assembly and the steering column & EPS unit assembly must not be disassemble to inspect or replace them. (Refer to “ST (Steering system) Gr.”)
DBC Switch: Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. 3. Check the continuity between the switch terminals as ...
Body (Interior and Exterior)
...
See also:

ENGINE START/STOP button: (if equipped). Starting the engine with the smart key
Operation OFF With the transmission in P (Park) on an automatic or dual clutch transmission, or N (Neutral) on a manual ...

Fuel Pressure Control Valve: Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel ...

Smart key unit: Components and Components Location
Components Connector Pin Information NoConnector A (14 Pin)NoConnector B (26 Pin)1Ground 11 -15L_Passenger lock button, L_Passenger toggle button2A_ACC2L_Driver lock button,L_Driver toggle ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0609