Kia Sportage: Transaxle Control Module (TCM): Repair procedures| Inspection |
| 1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
|
| 2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it. |
| 3. |
If problem is not found in Step 1 and 2, the TCM could be
faulty. If so, make sure there were no DTC''s before swapping the TCM
with a new one, and then check the vehicle again. If DTC''s were found,
examine this first before swapping TCM. |
| 4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be
broken) into a known-good vehicle and check the vehicle. If the problem
occurs again, replace the original TCM with a new one. If problem does
not occur, this is intermittent problem.
|
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery.
(Refer to "Charging System" in EE group) |
| 4. |
Remove the mounting bolts (A) and a nut (B), and then remove the ECM (C).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons
or turning knob(s) other than the AUTO button. In this case, the system works sequentially
according to the order of b ...
Child restraint system (CRS)
Our recommendation: Children should always be in the rear
Infants and young children must travel in a suitable rear-facing or forward-facing child restraint system (CRS),
correctly secured to a ve ...
Oil hydraulic Motor(Actuator): Description and Operation
Description
The 4WD ECM controls the Pump Motor Pump (Actuator) to
generating an oil pressure. The pressure engages a multiple disk clutch
to transfer torque to the rear wheels. The torque to t ...