Kia Sportage: Transmitter precautions - Remote keyless entry - Features of your vehicleKia Sportage: Transmitter precautions

Kia Sportage Owners Manual (3rd Generation, SL; 2011-2016) / Features of your vehicle / Remote keyless entry / Transmitter precautions

The transmitter will not work if any of the following occurs:

When the transmitter does not work properly, open and close the door with the ignition key. If you have a problem with the transmitter, contact an authorized Kia dealer.

CAUTION

Keep the smart key away from water or any liquid as it can become damaged and not function properly.

This device complies with Industry Canada Standard RSS-210.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

✽ NOTICE

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If the keyless entry system is inoperative due to changes or modifications not expressly approved by the party responsible for compliance, it will not be covered by your manufacturer’s vehicle warranty.

Remote keyless entry system operations
Lock (1) All doors (and tailgate) are locked if the lock button is pressed. If all doors (and tailgate) are closed, the hazard warning lights will blink once to indicate that all doors (and tailga...
Battery replacement
A transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1.Insert a slim tool into the slot and gently pry...
See also:

Seat belt precautions
WARNING Everyone travelling in the Kia Sportage must wear a seat belt at all times. Seat belts and child restraints help reduce the risk of serious or fatal injury during a collision or sudden sto ...

Output Speed Sensor: Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (R ...

Instrument panel illumination
When the ignition switch is on, press the illumination control button to adjust the brightness of the instrument panel illumination. ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0663