Kia Optima Manuals

Kia Sportage: Audio Remote Control: Repair procedures - Audio - Body Electrical SystemKia Sportage: Audio Remote Control: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Body Electrical System / Audio / Audio Remote Control: Repair procedures

Inspection
1.
Check for resistance between No.6 and No.7 terminals in each switch position.

[Audio System]
Switch
Connector
terminal
Resistance
(±5%)
Volume down
6 - 7
6.81 k?
Volume up
6 - 7
4.61 k?
Mute
6 - 7
3.11 k?
Mode
6 - 7
2.11 k?
Seek down
6 - 7
1.1 k?
Seek up
6 - 7
430 ?

2.
Check for voltage between No.6 and No.7 terminal in each switch position.
[Audio System]
Switch
Connector
terminal
Output voltage
(±0.22V)
Volume down
6 - 7
3
Volume up
6 - 7
2.5
Mute
6 - 7
2
Mode
6 - 7
1.5
Seek down
6 - 7
1
Seek up
6 - 7
0.4

Removal
1.
Remove the driver airbag module.
(Refer to the RT group - "Airbag module")
2.
Remove the steering wheel remote control switch mounting screws (2EA).
Disconnect the connector and remove the steering wheel remote control switch (A).

Installation
1.
Install the audio remote control switch on the steering wheel.
2.
Reconnect the audio remote control switch connector and airbag connectors.
   
Make sure that the switch connector is plugged in properly.
3.
Install the driver airbag module.
   
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Make sure horn button works.
Audio Remote Control: Schematic Diagrams
Circuit Diagram...
AUX(Auxiliary) Jack: Schematic Diagrams
Circuit Diagram...
See also:

Parking Collision-Avoidance Assist Malfunction
A: Check Driver Assistance system. If Parking Collision-Avoidance Assist or one of its related components develops a problem, a warning message ...

Relay Box (Passenger Compartment): Repair procedures
Inspection Fuse 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are there any blown fuses? ...

Front Wheel Speed Sensor: Repair procedures
Removal 1. Remove the front wheel speed sensor mounting bolt (A). Tightening torque: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) 2. Remove the front wheel guard . 3. Disconnect ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0548