Kia Sportage: Front Bumper: Repair procedures - Bumper - Body (Interior and Exterior)Kia Sportage: Front Bumper: Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Body (Interior and Exterior) / Bumper / Front Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips and bolts.

2.
Remove the under cover (A) mounting clips.

3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
   
•
When you pull out the front bumper, the front bumper could be damaged by the projection (A).

4.
Disconnect the fog lamp (A), turn signal lamp (B), front sensor (C).
5.
Remove the front bumper.
[LH]

[RH]

6.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Front Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [LH]3. Front bumper side bracket [RH]...
Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH]...
See also:

TPMS Receiver: Schematic Diagrams
Schematic Diagrams TPMS Receiver Circuit Diagram Harness Connector PinDescription1Battery2CAN_High3GND4-5-6-7IGN8CAN_Low9-10-11-12- ...

Used Vehicle and Digital Key 2 Maintenance. System Limitations
Used Vehicle and Digital Key 2 Maintenance Purchasing a Used Vehicle When you buy a used Kia Sportage, delete any smartphone and card keys (if equipped) registered by the previous owner. Tell an a ...

Rear Washer Motor: Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.     Before filling the reservoir tank with water, check the fil ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.0708