Kia Optima Manuals

Kia Sportage: Heated Oxygen Sensor (HO2S): Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Sportage: Heated Oxygen Sensor (HO2S): Repair procedures

Kia Sportage Service & Repair Manual (3rd Generation, SL; 2011-2016) / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S): Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
[Bank 1 / Sensor 1]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
   
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 2]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the console side cover (A).

3.
Disconnect the connector (A), and then remove the sensor (B).
   
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
•
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Installation is reverse of removal.
Heated oxygen sensor installation [Bank 1/Sensor1]:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated oxygen sensor installation[Bank 1/Sensor2]:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated Oxygen Sensor (HO2S): Schematic Diagrams
Circuit Diagram...
Rail Pressure Sensor (RPS): Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...
See also:

Transaxle Oil Temperature Sensor: Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). 3. Remove the air cleaner assembly. (1) Disconnect the breather hose (A) and brake booster intensifier hose. (2) ...

Engine Coolant Temperature Sensor (ECTS): Schematic Diagrams
Circuit Diagram ...

SS-B Solenoid Valve(ON/OFF): Specifications
Specifications ON/OFF Solenoid Valve(SS-B) ? Control type : Normal low type Control pressure kpa (kgf/cm?, psi)490.33(5.0, 71.12) Internal resistance(?)10 ~ 11 ...

Categories

Copyright © sl.kispmanual.com 2014-2026 - 0.07