Kia Sportage: Repair procedures| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the steering column upper and lower shrouds (A) after removing 3 screws.
|
| 3. |
Disconnect the light switch connector (A) and the wiper switch connector (B).
|
| 4. |
Remove the wiper switch (A) by pushing the lock pin (B).
|
| 5. |
Remove the steering wheel.
(Refer to the ST group - "Steering column and shaft") |
| 6. |
Remove the clock spring.
(Refer to the RT group - "Airbag module") |
| 7. |
Loosen the 2 screws from the multifunction switch assembly (A).
|
| Installation |
| 1. |
Install the multifunction switch. |
| 2. |
Install the clock spring and steering wheel. |
| 3. |
Install the steering column upper and lower shrouds. |
| 4. |
Install the steering wheel. |
| Inspection |
| 1. |
With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.
Lighting switch (Auto Light)
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
| 1. |
With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
|
| Inspection (With GDS) |
| 1. |
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch. |
| 2. |
If diagnosis is required on the multifunction switch, select model and "BCM".
|
| 3. |
Select "Current data" and check the input/output condition of "Multifunction switch".
|
| 4. |
To perform test on "Multifunction switch" outputs, select "Actuation test".
|
Rear View Monitor (RVM): (if equipped)
Rear View Monitor displays the area behind the Kia Sportage to assist the driver when reversing, parking or moving
the vehicle.
Detecting sensor
For information about the applicable sensors and t ...
Inhibitor Switch: Description and Operation
Description
Inhibitor Switch monitors the lever''s position(P, R, N, D) and is used to control gear setting signals. ...
Windshield Wiper-Washer Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.
Take care not to damag ...